Carb Cables Needed

[82SRX500]

Guys, I am not much for knowledge on engine and carbs so I am asking for some direction from you guys. I need to get 2 throttle cables and 2 choke cables that look like the ones pictured below in the attached photos. These will pull Mikuni Flat Slide TM carbs. Each cable pulls two carbs. So 2 throttle and 2 chokes for a VMAX 4.

Can someone tell me a part number for these two cables and a place that I can call to order them?

Email me at: toizrit@comcast.net

Thanks,


Jon Bertolino

 

[YAMMIEGOD 3:16]

JOHN, YOU NEED THE YAMAHA PART NUMBER OR YOU LOOKING FOR AFTERMARKET ? 3:16 (yammie tony)

 

[82SRX500]

JOHN, YOU NEED THE YAMAHA PART NUMBER OR YOU LOOKING FOR AFTERMARKET ? 3:16 (yammie tony)

On these carbs I can use aftermarket. They are Mikuni TMX slides either a 36 or 38MM.

 

[YAMMIEGOD 3:16]

I DON,T KNOW WHY YOU COULD NOT USE AFTERMARKET. THEIR MIKUNI CARBS. 3:16 (yammie tony)

 

[luckyone]

jon, call motion pro,650-594-9600 they should be able to help you out.

 

[toydoc]

For cheap throttle cables:
http://www.jrgraham.com/jrgc/hsrun.exe/webapps/jrg/StateId/RfU-uGKns2mAVJ2nt4qsUuJrZ0RSq-4dMz/HAHTpage/CatalogItemInfo?ITNO=KX051392&RECTYPE=IS

For the better $$ Hi-Lex cables:
http://www.wahlracing.com/store/product_info.php?products_id=908

I use both, but the Hi-Lex are nice.

Make sure the TMX's have the 1.8 needle and seat assy #786-36004-A for fuel pump motors.

 

[SRV540]

Motion pro are great...they made up custom throttle cable for my RZ they even made up my 5/8 offset sprockets.....sent them my sprockets.